amplifier

Now you can start the installation. You must ensure that all power is broken. This is for safety. Therefore, you should disconnect the negative battery cable. Take the side with the assurance of supply (positive) and red tie it to the terminal to the positive terminal of the battery. You can then secure the wire in the fuse area.
Now you can power amplifier for your car to the firewall. Be careful what you wish to run the wire. Take the power cable near the speaker wires or signal. Then you can connect to a metal screw in your car near the amp to the negative terminal. Make sure the distance of less than 3 meters. Loosen the screws and clean the surface with sandpaper. Attach the floor to him with a pair of O-ring. If you have had with him, turn the screw.
Now that you have RCA jacks and remote control on the ball to the back of the car. Then you can find them all. Finally, make a check to make sure everything works properly.Audio and Video | Tags: cable rca, car audio system, iphone, metal screw, negative battery cable, negative terminal, o ring, power amplifier, power cable, rca cable, rca jacks, sandpaper, speaker wires, wire cutters, wire stripper

• Cooler Air inside the House with the Best Air Conditioning
• Everything is available in Internet
• Cute Stuff for Kids
• Something Fun and Colorful
• Find Car Rental Service for your Holiday